Page of GC20-1806-9 As Updated April 1, 1981 by TNL GN25-0834 If the attached processor was generated as part of the system but vas
not online, the following message is issued if the multiprocessing
feature is installed: DMKCPI959W ATTACHED PROCESSOR NOT ONLINE If the attached processor is not required, processing can continue.
However, if the attached processor is required, the operator should
ready the unit and reload the system.
Assuminq AP=YES and the attached processor was online the following
message is issued. DMKCPI958r PROCESSOR NOW OPERATIONAL No operator action is required; the system will now utilize the attached
processor.
If the installation is running with an attached processor, the system
operator will be issued the following message when the clocks are to be
synchronized. CLOCK SYNCHRONIZATION-PRESS 'TOD ENABLE SET' The operator will then press the TOD SET key on either
processor to synchronize the TOD clocks. Note that once the clocks are
synchronized, it will not be necessary to resynchronize the clocks on subsequent IPL operations unless: • FE diagnostics are run • Power is turned off on either processor • The clocks are running but not synchronized • A clock's error is encountered during initialization
Section 2. Initiating VK/370 Operation 18.1

April 1, 1981
18.2 VM/370 Operator's Guide