FORCE Use the FORCE com.and to force a logoff of any user on the system. The format of the FORCE command is: FORCE userid
userid is the user identification of the user who is to be logged
off.
The user receives the normal accounting message at logoff and a
logoff aessage of the following format: LOGOFF AT hh:mm:ss zone weekday .m/dd/yy BY SYSTEe The primary system operator receives the following message:
{ GRIF raddr}
LIBE raddr LOGOFF AS userid USERS = DEV rid DSCOBBECT nnn FORCED !!here: raddr is the real line address.
rid is the real resource identifier.
userid is the identification of the user who was logged off.
nnn is the number of users remaining on the systea. !Qte:. I virtual user may be forced into a disconnected state by the system if an unrecoverable I/O error occurs on the virtual console. The
preceeding message will then be issued with DSCONNECT rather than LOGOFFe The user may log on at any time while his disconnected machine is still running •. See the for further information.
76 V8/370 Operator's Guide
FREE Use the FREE com.and to remove a set of spool files belonging to a
specified user from a system hold status. A spool file held by a
spooling operator can only be freed by a spooling operator; a spool
file held by a user can be freed by that user or the spooling operator.
A spool file can be in a double hold status and can only be processed
after both holds (system and user) are removed.
with the HOLD command. It can
a hold status. The hold status
The FREE command works in conjunction
free only those output files that are in
of a file is its pending status; that
called for spooling output. Use HOLD to
files temporarily to correct or modify a
files from spooled output severely impacts
is, it is neither purged nor
detain a file or a group of
spooling condition. Blocking
available spooling area.
A particular file may be held from output because of a device
restriction, an I/O error on the printer or punch, or a device
modification. (For example, a printer may not be available, or it may
have an incorrect print train mounted.) When the condition is
corrected, the files can then be released for output. The format of the
FREE command is: t I I I FRee I I userid PRINTER PRT PUNCH PCH ALL
None.
use rid r , IPrinterl IPUnch I 11LL I L J is the user whose spool files are to be released from a syste.
hold status. The·user need not be legged on, but his files may have previously been held by the HOLD command. frees the printer files for the specified user.
frees the punch files for the specified user.
frees all printer and punch files for the specified user.
Section 3. CP Commands 11
Previous Page Next Page