Page of GC20-1834-0 As Updated Aug. 1, 1979 by TNL GN25-0486 No documentation is provided with the optional program material. For related documentation, see "Additional Publications."
Additional Publications
The V"/370 user can obtain the following manuals through his IBM representative or local IB" branch office, or order them directly from SLSS ("echanicsburg). Order Number GC20-1800 GC20-1809 GC20-1810 GC20-1813
GC20-1816
GC20-1821
GC20-1823
GBOF-3573 GX20-1926 GX20-1961 GX20-1995 SY20-0882 SY20-0884 SBOF-3802 SY20-0886 SY20-0887 SY20..,.0888 Title IB" Virtual "achine Facility/370:
Introduction OLTSEP and Error Recording Guide
Terminai User's Guide
Glossary and "aster Index
Remote Spooling Communication Subsystem (RSCS) User's Guide
Operating Systems in a Virtual Machine Interactive Problem Control System (IPCS) User's Guide Use to order the following group
Quick Guide for Users Commands (General Users) Commands (Other than General Users) Service Routines Program Logic
Data Areas and Control Block Logic Use to order the following group System Logic and Problem Determination Vol. 1
Control Program (CP) System Logic and Problem Determination Vol. 2
Conversational "onitor System (CMS) System Logic and Problem Determination Vol. 3
Remote Spool. Comm. Subsys. (RSCS) GC33=4010 OS/VS, nOS/Vs, and VM/370 Assembler Language "anual GC33-4021 OS/VS, DOS/VS, and VM/370 CMS Ass-embler Guide GC38-1000 OS/VS Message Library: Mass Storage System (MSS) Messages SY28-0773 OS/VS, DOS/VSE, VM/370 Environmental Recording,
Editing, and Printing (EREP) Program Logic SY33-8041 OS/VS and VM/370 CMS Assembler Logic Manual A program logic manual is not available for VM/370 IPCS; refer to !!L370 Service Routine§ Logic. VM/370 program listings are available on microfiche. The listings are
the equivalent of output listings produced by assembling each of the
source programs. CP listings reflect macro expansion for the uniprocessor mode of operation (AP=O or not attached processor) attached
processor where applicable. In addition, the attached processor
listings (AP=1) are also available. Section 5. Ordering and Distribution Procedures 5-3
5IBO-0900 SIBO-0901 SICO-9000 SICO-9001 SICO-9002 Aug- 1, 1979 CP Listings and CP Label Cross-References
Microfiche CMS Listings and CMS Label Cross-Reference
Microfiche RSCS Listing and RSCS Label Cross-Reference
Microfiche IPCS Listing and IPCS Label Cross-Reference
Microfiche CP (AP) Listings and CP label Cross-Reference
Microfiche Microfiche for linkage editor and EREP support under 6 is
not provided under the VM/310 Microfiche order number but can be ordered
using the following number:
Linkage Editor Component ID 5141-SC1-04 Microfiche Order SJD2-2068 OS/VS2 EREP Listings Component Level 3.8
Microfiche Order SJD2-2156-00 TNL No. SNC8-0001 Program Materials list BASIC SISTEM TAPES The starter system tape format is: DMKFMT (Format Service Program) EOFITM DMKDDR (DASD Dump Restore Service Program) EOF/TM VM/310 Starter System consists of: CP nucleus CP libraries CMS system CMS libraries EOF/TM 5-4 IBM VM/310 Release 6 Guide
Previous Page Next Page