Figure 16. Operator's Panel
66
Figure 16. Operator's Panel
66
Figure 16. Operator's Panel
66
Table IV. Meter Operation under Various TPS Conditions Switch Position TPS State :--' CPU 1 CPU 2
NeutralON ON CPU 1 attached CPU 2 attached OFF ON Neutral CPU 2 attached ON OFF Neutral CPU 1 attached OFF OFF Neutral I NOTES:
1. Metering-In. Metering-In is a line from all
attached control units and is used to condition
theCPU meter for operation. The Metering
In signal originates from eachI/O device and/
or control unit and is generated by the device
from the time of acceptance of a command un
til the generation of Device End for that com
mand.
Meter is Running when
MeteringOut is Active for CPU 1, or CPU 2 CPU 1 only CPU 2 only CPU 2 only CPU 2 only CPU 1 only CPU 1 only
Meter isneyer active
regardless of MeteringOut I from either CPU 1 or CPU 2.
2. Metering-Out.Metering-Out is a line from
the channel to all attached control units and is
used to condition allmeters in assignable
units andI/O units. Metering-Out is raised
whenever theCPU meter is recording time.
67
Neutral
1. Metering-In. Metering-In is a line from all
attached control units and is used to condition
the
In signal originates from each
or control unit and is generated by the device
from the time of acceptance of a command un
til the generation of Device End for that com
mand.
Meter is Running when
Metering
Meter is
regardless of Metering
2. Metering-Out.
the channel to all attached control units and is
used to condition all
units and
whenever the
67
