Example 2:
Set the automatic creation of empty tape files to ‘ON’.
23:05:25.148 00000ABC HHC00013I Herc command: 'autoinit on'
23:05:25.148 00000ABC HHC02204I Value 'autoinit' set to 'on'
Figure 32: AUTOINIT command (change setting)
Example 2:
Set the automatic creation of empty tape files to ‘ON’.
23:05:25.148 00000ABC HHC00013I Herc command: 'autoinit on'
23:05:25.148 00000ABC HHC02204I Value 'autoinit' set to 'on'
Figure 32: AUTOINIT command (change setting)
The AUTOMOUNT command allows it to add or delete entries from the list of allowable/unallowable tape
automount directories, or lists all currently defined list entries, if any.
The format of the directory operand for add/del operations is identical to that as described in the docu-
mentation for the AUTOMOUNT system parameter (i.e. prefix with '+' or '-' as needed).
The automount feature is appropriately enabled or disabled for all tape devices as needed depending on
the updated empty/non-empty list state.
Descriptive
directory directory
or
[
+ - ]directory
Diagram
~¬¬¬ + ¬¬¬®
¦¬¬¬¬¬¬¬¬¬¦¬¬¬ directory ¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬ÊÍ
-
or
directory ¬¬¬§¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬ÊÍ
directory
ADD or +
Add an entry to the list of allowable tape automount directories.
DEL or -
Delete an entry from the list of allowable tape automount directories.
LIST
List all currently defined list entries of allowable tape automount directories.
directory
Specifies the host system directory where the guest is allowed or not to
automatically load virtual tape volumes from.
Powered by Tizra® |