8.122 PTP (Enable / disable PTP debugging)

8.122.1 Function

The PTP command enables or disables debug tracing for the device group identified by devnum or for all
device group(s) if devnum is not specified or specified as ‘ALL’.

8.122.2 Syntax

Descriptive

ALL] [
mask]

Diagram

~¬¬¬¬ ALL ¬¬¬¬¬®

Êʬ¬¬ PTP ¬¬¬¬¬¬¬¬¬¬¬¬§¬¬¬¬ÊÍ

mask

8.122.3 Parameter

ON

Enables the PTP debug tracing.

OFF

Disables the PTP debug packet tracing.

devnum

Specifies the PTP device group(s) for which debug tracing has to be enabled or
disabled.

ALL

Enables or disables the debug tracing for all PTP device groups. 'ALL' is the default
if no device group is specified.

mask

Specifies the type of debug output to be produced. mask is a value from 1 to 255.
The following debug output can be selected:

8.122.4 Examples

Example 1:

Enable the debug tracing for all PTP devices. Please note that not all hex columns can be displayed in
the figure below. Missing columns have been marked with “”.

HHC00013I Herc command: 'ptp debug on all'

HHC02204I PTP debug set to on ALL

.

.

.

Figure 232: PTP command (enable debug tracing)

Example 2:

Disable the PTP debug tracing.

HHC00013I Herc command: 'ptp debug off'

HHC02204I PTP debug set to off

Figure 233: PTP command (disable debug tracing)