Example 1:
Display the number of installed processor engines.
HHC00013I Herc command: 'maxcpu'
HHC02203I maxcpu : 2
Figure 185: MAXCPU command (display current number of installed processors)
Example 2:
Set the maximum number of installed processor engines to 8.
HHC00013I Herc command: 'maxcpu 8'
HHC02204I maxcpu set to 8
Figure 186: MAXCPU command (set number of installed processors)
The MAXRATES command shows the maximum observed MIPS (million instructions per second) and
SIO (Start I/O) rates reached during the current reporting interval (up to the time the command is issued).
It lets you also set the MAXRATES reporting interval to a new value.
If there is no MAXRATES reporting interval set in the configuration file then the default value for reporting
the rates is 1440 minutes (1 day). When the interval is expired a MAXRATES command is automatically
issued. The current rates will also be displayed during shutdown of Hercules.
Descriptive
]
Diagram
¬¬§¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬¬ÊÍ
¬¬¬«
interval
This is the new interval time in minutes. The default MAXRATES interval that is
active after startup of Hercules (if not otherwise specified in the configuration file),
is 1440 minutes (1 day). Changes to the MAXRATES interval that are other than
“MIDNIGHT” will set the current interval start time to the present; this includes a
value of “1440”.
MIDNIGHT
Sets the interval to 1440 minutes (1 day) and the start time for the interval timer to
midnight of the current day. This will cause the MAXRATE statistics to be date
aligned.
Powered by Tizra® |
