DDR
ENTER: Prompts for input from the terminal. A null line (that iS r the Enter key or equivalent) causes control to return to CMS if the virtual machine is in the CKS environment. DMKDDR725R ORIGINAL INPUT DEVICE WAS (IS) LARGER THAN OUTPUT DEVICE. DO YOU WISH TO CONTINUE? RESPONSE YES OR NJ: RESTORE function -The number of cylinders on the
input unit is compared with the number of cylinders
device.
original DASD on the output COpy function -The input device contains more cylinders than the
output device. The operator must determine if the COpy or RESTORE function is to continue. The response is either yes or no. Except as shown, there is no return code returned for the
following messages. DMKDDR700E INPUT UNIT IS NOT A CPVOL DMKDDR701E INVALID OPERAND - operand DMKDDR
7
02E
CONTROL STATEMENT SEQUENCE ERROR DMKDDR703E OPERAND MISSING DMKDDR704E DEV cuu NOT OPERATIONAL DMKDDR
1 05E
10 ERROR cuu CSW csw SENSE sense INPUT bbcchh OUTPUT bbcchh
CCW ccw DMKDDR 7 07E MACHINE CHECK RUN SEFEP AND SAVE OUTPUT FaR CE DMKDDR708E INVALID INPUT OR OUTPUT DEFINITION DMKDDR 7 09E WRONG INPUT TAPE MOUNTED DMKDDR
1 10A
DEV cuu INTERVENTION REQUIRED DMKDDR712E NUMBER OF EXCEEDS 20 DMKDDR713E OVERLAPPING OR INVALID EXTENTS DMKDDR714E RECORD bbcchh NOT FOUND ON TAPE DMKDDR715E LOCATION bbcchh IS A FLAGGED TRACK RC=3 DMKDDR718E OUTPUT UNIT IS FILE PROTECTED RC=1
DMKDDR719E INVALID FILENAME OR FILE NOT FOUND DMKDDR720E ERROR IN routine RC=varies
DMKDDR721E RECORD cchhr NOT FOUND DMKDDR722E OUTPUT UNIT NOT PROPEFLY FORMATTED FOR THE CP NUCLEUS DMKDDR723E NO VALID CP NUCLEUS ON THE INPUT UNIT DMKDDR724E INPUT TAPE CONTAINS A CP NUCLEUS DUMP DMKDDR756E PROGRAM CHECK PSW=psw 56 IBM VM/370 CMS Command and Macro Reference
DEBUG DeBUG Use the DEBUG command to enter the debug environment from the CMS environment. In the debug environment you can use a variety of DEBUG subcommands that allow you to test and debug your programs. The DEBUG subcommands are described in "Section 4. DEBUG Subcommands.
u
For
tutorial information, including examples, see the The format of the DEBUG command is:
r --------------------------------------------------------------, I I L- ____ __
1 The debug environment is also entered
interruption or the result of a
encountered during program execution.
as a result of an external
breakpoint (address stop)
2. Once you are in the debug environment, you can enter only DEBUG subcommands and CP commands via the ICP function.
3. To return to the eMS environment, enter the DEBUG subcommand DMSDBG728I DEBUG ENTERED
This message indicates that you are in the debug environment. Section 2. CMS Commands 57
Previous Page Next Page