226 IBM VM/370 and System Generation Guide

Introduction
Before you start to install be sure you have the following
available: • Two real disk drives • At least one real tape drive (the system generation process is
simpler if you use two tape drives) • Two scratch disks (one is used for the starter system and the other
is used for the new system residence volume) • The starter system tape • The system Program Update Tape (PUT) • At least one scratch tape
The system generation procedures described in this manual refer to
related publications. These publications are listed in the Preface.
The following procedures for installing CP and are described: • 2314 starter system • 3330 starter system • 3340 starter system • 3350 starter system
From these starter systems you can generate a system for
residence on a 2305, 2314, 3330,3340, or 3350. (It is recommended,
however, that 2305 devices be used for paging rather than for system
residence; therefore the 2305 is not included in the system generation
procedures. )
An 3330V volume may not be used for system residence. You can then load and save the discontiguous saved segments your
installation may wish to usee Following the procedures for installing CP and CMS are the procedures
for installing the optional RSCS (Remote Spooling Communications
Subsystem) component of the SCP.
In addition, the information you
control program is found in "Part 4. Program. " need to install the 3704/3705 Generating the 3704/3705 Control
Part 3. Generating (CP, RSCS, and IPCS) 227