Condition Code Instruction 0 2 3 Input/Output Instructions CLEAR I/O no operation CSW stored channel busy not operational
in progress
HALTDEVICE interruption CSW stored channel working not operational
pending, or busy
HALTI/O interruption CSW stored burst op. stopped not operational pending START I/O successful CSW stored busy not operational START I/O FAST RELEASE successful CSW stored busy not operational STORE CHANNEL ID ID stored CSW stored busy not operational TEST CHANNEL available interruption burst mode not operational pending TEST I/O available CSW stored busy not operational System Control Instructions LOAD REAL ADDRESS translation ST entry invalid PT entry invalid length violation available RESET REFERENCE BIT R
bit zero, R
bit zero, R
bit one, R
bit one,
C
bit zero C
bit one C
bit zero C
bit oneSET CLOCK set secure not operational SIGNAL PROCESSOR order code status stored busy not operational accepted Explanation: >ze.:o-Result is greater than zero.
high First operand compares high.
< zeroResult is less than zero. low First operand compares low. The condition code may also be changed by LOAD PSW, SET PROGRAM MASK, and DIAGNOSE, and by an interruption.
Condition-Code Settings(Part 2 of 2)
276System/370 Principles of Operation
in progress
HALT
pending, or busy
HALT
bit zero, R
bit zero, R
bit one, R
bit one,
C
bit zero C
bit one C
bit zero C
bit one
high First operand compares high.
< zero
Condition-Code Settings
276