Page of SA21-9213-0
Issued 15 September 1975
By TNL: SN21-0247
Tractors
A
5.
6.
7.
8.
9.
10.
Platen
Tractor Cover and Pins
I
Roliers
11.
12.
13.
14.
Paper-Advance Knob
I 15.
Right Tractor Knobs
I
Paper- Adiance Knob
Tractor Cover and Pins
16.
17.
Place the forms in position behind the printer.
Note: The forms must be positioned behind the
printer so that the forms feed squarely into the printer.
Thread the paper down, over the rollers, behind the
tractors, and behind the platen.
Turn the paper-advance knob to move the paper around
the platen until you can grasp it with your fingers.
Open both tractor covers.
Pull the paper release lever forward to disengage the
friction feed rolls.
Pull the paper up and place the left margin holes over
the tractor pins. Be sure the left tractor is in its left-
most position.
Close the left tractor cover.
Squeeze the two knobs on the right tractor and slide
the tractor to align the pins with the right margin holes.
Place the right margin holes over the tractor pins.
Close the right tractor cover.
For singlepart forms, pivot the form guide rack to a
horizontal position.
Turn either paper-advance knob to position the form
for the first line to be
printed. The paper should
exit over the form guide rack.
Note: To move the form backward, turn either
paper-advance knob backward and pull the form
from behind the printer to keep the form from buck-
ling at the print head.
Close the plastic shield. If you are installing the
printer, return to step 7 of Printer Installation
Procedures.
CAUTlO N
The switch that senses end of forms is deactivated
friction feed rolls are engaged. Thus, the print wir
hit the base platen if no forms are in the printer.
when the
'es could
176

HOW TO ADJUST THE COPY CONTROL DIAL FOR FORMS THICKNESS
Copy Control Dial
I
HOW TO REPLACE
Forms Tractor
A RIBBON
Power On Switch Printer Cover
If you are using singlepart forms, set the copy
control dial on 0.
If you are using multipart forms and the last sheet
is not legible, rotate the copy control dial toward 0
one click at a time to obtain the legibility you desire.
If you are using multipart forms and the ribbon is
smudging the first sheet, rotate the copy control
dial toward 8 one click at a time until smudging
stops.
Turn off power to the printer.
Tilt the forms tractor back by
front.
Raise the printer cover.
lifting both sides at the
177