October 1, 1979 FORMATTING ALTER CODES
GRID
5. The horizontal subgrid was then expanded to a length of 2 in
the vertical direction.
2 GRID code: !+grid(a4,2b4,c)2,(d4,2e4,f)_+
Generates:



6. A vertical iteration factor of three was used to indicate
that the expanded horizontal subgrid was to appear three
times.
3 GRID code: !+grid(a4,2b4,c)2,_(d4,2e4,f)2+
Generates:







7. Finally, the grid was "closed" by using the symbols G, H, and
I, which were expanded and iterated as above.
,(g4,2h4,i) GRID code: !+grid(a4,2b4,c)2,3(d4,2e4,f)2___________+
Generates:








8. Text was entered into the grid by entering the following
lines immediately after the !+GRID+ code:
!-s0;t2-A!-t-B!-t-C
!-s1;t2-D!-t-E!-t-F
and so on. Note that Skip edit codes (!-S-) were used in
such a way as to avoid overlaying the lines of the grid.
46 -- Section 4. Release 9.1 FRESS Resource Manual
October 1, 1979 FORMATTING ALTER CODES
GUTTER


!+GUTTER+


!+GUTTER+ set gutter size between columns __________________________________________
This code determines the amount of space (the "gutter") between
columns.


!+GUTTER<separation>+
3 _


<separation>...the spacing between columns
EXAMPLES ________
!+GUTTER4+!+COLUMN2+ ____________________
Starting at the point where these codes are located, the
text will be formatted into two columns of equal width: the
first column from position 0 to 30, the second column from
position 34 to 64 (the "gutter" is four spaces).
FRESS Resource Manual Release 9.1 FRESS ReSection 4.3 -- 47
Previous Page Next Page