October 1, 1979 FORMATTING ALTER CODES
select HEADING table
NOTES _____
The six heading levels (!-H- edit codes as well as Decimal
Block headings) are characterized by either Table A or Table B
as described in Figure 4.6.
Table A (the system defined table) will always be the same, but
the user can redefine Table B through the use of !+HEAD+ define
heading codes.
EXAMPLES ________
If !+HEADB+ is specified, each subsequent !-H2- code would
force the heading text to upper case, underscore it and skip
three lines before and two lines after the heading text.
Table A can be thought of as being defined by the following
codes: !+HEAD1=37,0,5+, !+HEAD2=36,2,1+, !+HEAD3=4,2,1+,
!+HEAD4=32,1,1+, !+HEAD5=36,1,1+, !+HEAD6=32,1,0+.
Table B defaults to by the following codes: !+HEAD1=37,0,5+,
!+HEAD2=36,3,2+, !+HEAD3=4,3,2+, !+HEAD4=32,3,2+,
!+HEAD5=36,1,0+, !+HEAD6=32,1,0+.
50 -- Section 4. Release 9.1 FRESS Resource Manual
October 1, 1979 FORMATTING ALTER CODES
set JUSTIFICATION


!+JUST+


!+JUST+ set justification mode _________________________________
This code sets the column and line justification modes.


!+JUST<line>+

or

!+JUST<col>[;<line>]+
C0 L0 __ __
C1 L1
C2 L2
C3 L3


<col> -- column justification:
C0 -- full widow elimination, padding and balancing
C1 -- no column padding
C2 -- no widow elimination (implies C1)
C3 -- no column balancing (implies C1 and C2)
<line> -- line justification
L0 -- fully justified lines
L1 -- bell justification (lines centered, no blanks added)
L2 -- text set flush left with ragged right margin
L3 -- text set flush right with ragged left margin
NOTES _____
For a more complete discussion of the justification algorithms,
see Appendix A.
When changing justification on the same physical page, skip
codes (or possibly other edit codes which start new lines) must
precede the text with the new justification. In other words,
the new justification [2] is not invoked until a new line is
started. The order of the required format codes must be:
(!+JUST+ code [2]) !-S<n>-(the lines to be justified under
!+JUST+ [2]
(!+JUST+ code [1]) !-S<n>-(the rest of the text)
FRESS Resource Manual Release 9.1 FRESS ReSection 4.3 -- 51
Previous Page Next Page