SET 3. To ensure the definition of a pf key for the COpy function, you can
either start with one leadinq blank before the keyword COpy or follow the keyword with at least five blanks.
4. The existence of more than one data fileid (cuu or residt following
the keyword Cooy, identifies the string as pfdata rather than a
hardcopy request.
1. System values for SET operands or the values set by previously invoken SET command operands can be dgtermined by the
use of the QUERY command.
2. SET rIMER REAL must be specified if an interrupt-driven system such as Customer Information Control System (CICS) is to be run in a
virtual machine. 3. Both SET PFnn TAB and SET PFnn COpy are executed immediately upon
pressing the appropriate program function key. If you insert the keywor1s DELAYED or IMMED after the PFnn operand, the command is
accepted, but the keyword is ignored. The program function still
executes immediately.
4. In the case of systems with attached processors, the VM/370 assists may be installed on none, one, or both processors. Similarly, hardware assist, if equipped on both processors of an
attached processor system, can be activated for none, either, or
both systems by the system operator. Thus, with the AFFINITY setting of a virtual machine, the user can receive no response
indi:ating that VM/370 hardware assist is installed and active on
his pro:essor. In attached processor setups where the user has no
processor preference (AFFINITY=NONE) upon entering SET ASSIST he too receives no response if either processor has VM/370 hardware
assist active. Any error message is indicative that VM/370 assist is not available or active for user. If the user
receives a message indicating that VM/370 hardware assist is not
available on a particular processor it is also implying that it is
available on the other processor. Therefore, the user, to take advantage of VM/370 hardware, need only change his affinity
setting, then initiate the SET ASSIST command. If you use the SET PFnn command to set up a series of concatenated you should be careful of line-editing characters. The examples demonstrate two methods for entering a series of
commands:
6. The SET RUN ON command should be issued before the user issues an ADSTC>P command.
Enter the following command while in CMS mode:
set linedit on
and press the ENTER key.
section 5. Format of CP Commands 137

Now enter one of the following commands:
#cp set of 02 immed q rdr#q prt#q pun
-- or
cp set pf02 immed q rdr"#q prt"#q pun
or
set pf02 immed q rdr"#g prt"#q pun
and press the key. CP assigns the three OUERY commands as functions of the PF02 key.
Pressing the PF02 key executes the three QUERY commands.
Enter the following command while in CMS mode:
set linedit off
and press the ENTER key.
Then enter:
set pf02 immed q rdr#q prt#q pun
or
cp set pf02 immed q rdr#g prt#q pun
and press the ENTER key. CP assigns the three QUERY commands as functions of the PF02 key.
Then enter:
set line3it on
and press the key.
Pressing the PF02 key executes the three QUERY commands.
None.
138 IBM VM/310 CP Command Reference for General Users